Instructions

01 The Pipe must be cut as square as possible with proper tool. Remove all burrs and dust with knife then round off the corners by 1 degree.

02 Marking the depth of entry is a good way to make sure for complete insertion.

03 Use only the solvent cement approved by MaxFlow for best results. Apply Solvent uniformly and more on the pipe and less on entrance to avoid the solvent cement from coming out.

04 Insert Pipe into fitting immediately without delay while solvent cement is still wet after solvent cement is applied. Remove any access solvent cement with rag. After Connection, hold the joined part in place for at least 1 minute in summer and 2 minutes in winter. Avoid any impact and bending until dry.